Are all trolling motor props the same?

One of the great thing about MotorGuide trolling motors is that nearly all of their lower motor units are standardized at 3.5”, which makes changing or upgrading your prop incredibly easy! … Additionally, all props use the same MotorGuide Prop Nut Kit.

What is the best prop for a trolling motor?

Here Are The 3 High Performance Trolling Motor Props, According To Customer Reviews:

  • Machette- III Motorguide Trolling Motor Prop.
  • Minn Kota MKP-2 Prop Upgrade.
  • Minn Kota MKP-7 Trolling Motor Replacement Prop.

Is a 3 blade prop better than 2 trolling motor?

As a general rule the two blade prop = more power but less weedless. Three and four blades = less power but more weedless. An exception would be Minn Kota’s Weedless Wedge props. They’re two bladed but are very weedless and give lots of thrust at the same time.

Can I put a bigger prop on my trolling motor?

Bottom line – a motor only has so much power and spin a propellor only so fast. If you try putting a larger prop on a motor that is not designed for it, the larger prop will simply spin more slowly so the net speed gain is 0 or negative.

IT IS INTERESTING:  Best answer: What type of gas turbine engine is used in helicopters?

Can you change the prop on a trolling motor?

It is recommended that you remove the propeller after every use to inspect for fishing line and weeds. NOTE: Only tighten the propeller nut / anode a 1/4 turn past snug [25-35 inch lbs.]. Over tightening can damage the propeller.

Is a 24v trolling motor faster than a 12v?

What you get in a 24v system is the ability to have a t-motor that delivers more “thrust”/power or more ability to push a (bigger) boat around easier and faster. You can have a lower thrust 12v t-motor wired with two 12v batteries and that will give you more hours of operating time.

How fast will a 40 lb thrust trolling motor go?

thrust trolling motor will still have a maximum speed of around 5 mph. If you are looking for quicker response time and better overall performance, bigger is better.

Are trolling motor props universal?

One of the great thing about MotorGuide trolling motors is that nearly all of their lower motor units are standardized at 3.5”, which makes changing or upgrading your prop incredibly easy! … Additionally, all props use the same MotorGuide Prop Nut Kit.

Which prop pitch is faster?

The lower the prop pitch, the better your hole-shot. However, this comes at a price: top speed. The lower pitch makes the engine reach maximum rpm at slower speeds. Conversely, a higher pitch will deliver greater top speeds, but slower acceleration.

How deep should my trolling motor be in the water?

Setting your trolling motor at an appropriate depth will help it to function properly, while at the same time reducing the risk of it becoming damaged. Remember, the general rule is to keep the motor submerged 12 inches below the water line.

IT IS INTERESTING:  Best answer: Why is the primary motor cortex important?

How much weight can a 30lb thrust trolling motor push?

So the maximum for a 30lb thrust motor would be 30*100/2= 1500lbs.

How do you remove the prop on a MotorGuide trolling motor?

While holding the propeller blade, use The MotorGuide Prop/Nut Wrench to loosen and remove the propeller nut. 2. Pull the propeller straight off. If the prop is struck, grasp one blade with one hand and tap lightly on the backside of the opposite blade with a rubber mallet.

Motorization