How do I identify a Ford 351 engine?

What 351 engine do I have?

The quickest way to identify a Ford 351 Windsor engine is to count the number of bolts on the valve covers. The valve covers are located on the top of the engine, one on either side of the air cleaner, and each will have six bolts.

How do I know if I have a 351W?

The easiest way to determine whether it is a 302 or 351 is to look next to the distributor hold down bolt & if there is a 45* support rib cast into the block, it is a 351.

How do you tell the difference between a 351 Cleveland and a 351 Windsor?

Three Easy Visual Differences Between the 351C and 351M

  1. Cleveland engines share a bellhousing bolt pattern with the Windsor family. …
  2. Due to a higher deck, the 351M’s intake manifold is wider than a 351C.
  3. Motor Mounts.351 Cleveland mounts use two bolts to attach to the engine, whereas the Modified uses three.
IT IS INTERESTING:  How do you calculate the resistance of a motor?

How do I know what Ford engine I have?

Locate the ID tag under coil attaching bolts for six-cylinder and some eight-cylinder engines. The tag is a series of numbers and letters etched in and used to decipher the year, make, and model of you engine. It is found underneath the bolts on the left or right side of the engine, near the front of the car.

Is the Ford 351 a good engine?

the 351w is a very good engine, it can handle a lot of power before the block splits, that usually happens at around 800hp. the 351m is an ok engine, good for use in trucks and for the basis of building a good 400. the 351c on the other hand is tough to beat, even by the chevy 350.

What year is the best 351 Windsor?

From what I have read, the best year for 351W blocks are 1969, 70, and 71. For some reason these were the strongest 351W ever produced, but very hard to find.

Is 302 better than 351W?

So for equal money, a 351 will have more cubes, more low end torque, and a lower RPM peak. A 302 will have the same HP, but a slightly higher tq peak with lower tq numbers. In almost any situation, cubes are better.

Which engine is better 351C or 351W?

In terms of power, the 351C in stock form was a more potent motor than the 351W in stock form, however either engine can be built up to most requirements. Another alternative to consider is the 351M which is the big block 351 than can be easily modified to a 400 cu-in.

IT IS INTERESTING:  What is the maximum torque of 3 phase induction motor?

How much horsepower is in a 351 Windsor?

Ford 351W V-8 Specs

Engine: Ford 351W V-8 (5.8L)
Peak Horsepower: • 1969 – 250 hp w/ 2 barrel carburetor, 300 hp @ 5,400 rpm w/ 4 barrel carburetor • 1972 (net power ratings adopted) – 153 hp w/ 2 barrel, 161 hp w/ 4 barrel • 1997 – 205 hp (CA version), 210 hp @ 3,600 rpm • Ford Lightning – 240 hp @ 4,200 rpm

Will 351 Windsor heads fit on a 351 Cleveland?

351C heads will not work on a 351W block without drilling new water jackets in the heads.

How much horsepower can you get out of a 351 Cleveland?

Factory rated at 330 hp at 5,400 rpm, this new engine was the highest output that this engine family would see. Other 351 performance engines would follow, but none would match the Boss 351.

How much horsepower can a 351 Cleveland block handle?

Registered. The hp on any block depends on many factors. The most obvious of course is how the block is casted which the 351C has an advantage in that area over any other ford small block. One block could crack at 500 hp while the other holds fine at 700+.

How do you identify a Cobra 429 engine?

The factory 429 CJ/SCJ engine will have ALL of the following casting numbers: Cylinder heads: D0OE-R. This number is located on the OUTSIDE of the head, along the valve cover mounting rail and between the 3rd and 4th exhaust ports. Any other casting number is NOT a Cobra Jet head of any kind.

IT IS INTERESTING:  How much does it cost to change spark plugs on a Jeep Grand Cherokee?

How can you tell a small block Ford?

Older Engines

The older 221 and 260 Ford small-blocks are easily identified. According to MRE-Books, these two engines use a five-bolt bell housing and are stamped with the casting code “C2OE” or “C3OE.” All Ford small-block casting codes are located on the right side of the engine block just above the starter.

What does the 8th digit of a VIN mean?

Vehicle Description Section

The fourth through eighth digits describe your vehicle’s model, body type, restraint system, transmission type, and engine code. The ninth digit is the check digit, which is used to detect fraudulent VINs.

Motorization