How do you install a Marinco trolling motor plug?

How do you install a Marinco plug?

  1. Pull the cover off the plug by pulling it back away from. the blades.
  2. Push the trolling motor wires through the openings at the. end of the cover. …
  3. Insert the negative wire into terminal 1 and the positive wire. into terminal 2. …
  4. Replace the strain relief and tighten the two strain relief.

Why does my trolling motor plug have 3 wires?

The three wires are for a trolling motor that will operate on either 12 volts or 24 volts. 12/24 volt motors have a switch to choose which you want. Thus the third wire to send power to the 24 volt side of the switch. The red and black wires operate the 12 volt side.

Are trolling motor plugs universal?

Unfortunately, most trolling motor plugs and receptacles are not compatible with each other as there isn’t a universal plug design.

Why does my trolling motor wires get hot?

Bad connection or undersized wire will cause excessive heat. … Then, go to your motor wires, and especially your trolling motor plug and connector. It is quite common after a few years that the trolling motor plug or connector or both get corroded, or simply go bad.

IT IS INTERESTING:  What protection is used to protect the motor from overheating?

Do I need a trolling motor plug?

A trolling motor plug allows you to safely remove the trolling motor, ensuring you don’t need to worry about connecting wires. They have become an essential accessory because they make your trolling motor’s wiring very easy to manage. Another point about trolling motor plugs is they make great power connection points.

What gauge wire should I use for my trolling motor?

In most cases, the manufactures recommended wire is 8 gauge for most 24-volt systems and 6 gauge for a system of 20 feet or longer. To account for voltage-drop, heat and current changes resulting from low batteries I recommend 6 gauge wire and 4 gauge for over 15 feet.

What is the best battery to use for a trolling motor?

10 Best Trolling Motor Batteries Compared

Battery: Type: Reserve:
1. BPS Pro Series AGM X-900 AGM 195 min
2. Odyssey Trolling Thunder AGM 135 min
3. BPS Pro Series Deep Cycle AGM 150 min
4. VMAX Charge Tanks MR-137 AGM 230 min

How do you wire a 12V trolling motor plug?

Feed the wires through the plug housing. On the 12-24V trolling motor plug, connect the positive 24V wire to the terminal marked “24”, the 12V wire to the terminal marked “12” and the negative wire to the terminal marked “-”. On straight 24V trolling motors, connect the two wires to “24” and “-” as appropriate.

Can you use a lithium battery for a trolling motor?

Lithium Ion batteries maintain higher voltages for longer periods of time than lead acid. Therefore, running a Minn Kota trolling motor at speeds higher than 85% for a prolonged period could cause permanent damage to the motor. The LiFePO4 Lithium batteries can be used with our motor.

IT IS INTERESTING:  Frequent question: Which of the following is used with a microcontroller to interface a DC motor?

Can you use a car battery on a trolling motor?

Will my car battery work for my trolling motor? No, car batteries are not recommended and can ruin your motor.

How do I know if my trolling motor is 12v or 24v?

The nameplates are most often found in the foot petals of the motor. Otherwise, you can look at the configuration of the trolling motor batteries to find the volts. Open the hood and look at the battery. If you see 6 cells, it’s a 12-volt battery, but if you see 12 cells, it means it’s a 24-volt battery.

Motorization