The 3800 is a reliable engine. I’ve seen quite a few over 200,000 miles. I’ve seen a lot over 100,000 miles with no problems. The two Camaros I’ve owned with the 3.8L were both in the 80,000 mile zone.
What GM cars have the 3800 engine?
The GM 3800, 3.8-liter V-6 came in the Chevrolet Monte Carlo, Malibu, El Camino, Impala, Monza, Caprice, Camaro and Lumina. Chevrolet replaced the Buick version with another 3.8-liter V-6 version, based on the Chevrolet 305 V-8, from 1980 to 1985.
When did GM stop making the 3800?
1988-2003: The 3800 becomes GM’s workhorse engine. The engine grew to 225 cubic inches in 1964. Production stopped in 1967, and GM sold engine and production tooling to the Kaiser-Jeep Corp., the company that owned the Jeep brand.
What is 3800 series engine?
The Buick V6, popularly referred to as the 3800 in its later incarnations, originally 198 cu in (3.2 L) and initially marketed as Fireball at its introduction in 1962, was a large V6 engine used by General Motors. The block is made of cast iron and all use two-valve-per-cylinder iron heads, actuated by pushrods.
Is the 3800 Series 3 a good engine?
The 3800 is a great engine, powerful, reliable.
How long do GM 3800 engines last?
The 3800 is a reliable engine. I’ve seen quite a few over 200,000 miles. I’ve seen a lot over 100,000 miles with no problems.
What is the most reliable GM car?
These Are The 15 Most Reliable 2020 Cars From General Motors
- 8 2020 Chevrolet Tahoe.
- 7 2020 GMC Sierra 1500.
- 6 2020 Cadillac Escalade.
- 5 2020 Chevrolet Camaro.
- 4 2020 Buick Enclave.
- 3 2020 Chevrolet Impala.
- 2 2020 GMC Acadia.
- 1 2020 Chevrolet Sonic.
Are 3.8 Motors Good?
The 3.8 liter V6 was a conservatively designed, wider-bore, longer-stroke version of the then-new 3.3-liter V6. It was a good, solid engine from the start – not the highest performer or the lowest, but relatively quiet, driveable, and reliable.
|Fuel ||Regular (US: 87 octane)|
Is a Grand Prix a muscle car?
An incredibly rare, and shockingly powerful muscle car, the Grand Prix Super Duty today is worth well into the 6-figures.
How much horsepower does a 3800 V6 have?
The supercharged 3800 Series III, found in the Grand Prix GT or GTP (depending on model year), unleashed 260 horsepower. The 3800 and 3800 SC Supercharged engines offered 230 foot-pounds of torque at 4,000 RPM and 380 foot-pounds of torque at 5,200 RPM, respectively.
What’s the biggest V6 ever made?
The displacement of modern V6 engines is typically between 2.5 to 3.5 L (153 to 214 cu in), though larger and smaller examples have been produced, such as the 1.8 L (110 cu in) Mazda V6 used in the 1991–1998 Mazda MX-3, or the 1.6 L (98 cu in) Mitsubishi V6 engine used in the 1992–1998 Mirage/Lancer, while the largest …
What cars have 3.8 supercharged?
That said, you can find supercharged 3800 engines in the 1996-2005 Buick Park Avenue Ultra, the 1997½-2004 Buick Regal GS, and the 1996-1999 Buick Riviera, as well as various models from Pontiac, Chevrolet, and other makes within the GM family.
Can you put a supercharger on a stock 3800?
One of the most common questions in the 3800 market is “Can I bolt a GTP supercharger onto my GT (L36) engine. The short answer is no. The only things the non supercharged and supercharged 3800’s have in common are the block and crank.
What’s the difference between a 3800 Series 2 and a 3800 Series 3?
The biggest difference between the motors is the Series III has stronger connecting rods, an aluminum upper plenum, which eliminated the leak point of the Series II, and it had a return-less fuel system setup.
Is the 3.9 gm a good engine?
A standard VVT 3.9 is a great engine. Can’t go wrong with any of the gen 3 3800 engine family. If you can find one with the 3.8 i would by it. We have not seen any real issues in our shop with 3.9,but the 3.8 was bullet proof.