Why is my trolling motor not spinning?

When a trolling motor prop stops spinning, there could be many reasons why. … First, you could have a broken prop drive pin. Second, your armature or brushes could have gone bad. Last, it could be an electrical issue within your control switch or control board.

What can cause a trolling motor to stop working?

The top six reasons why your electric troller motor is not working include battery failure, loose wires, an issue with the circuit breaker, or faulty wire connections. The problem could also be due to a broken rotary switch or a fault in the propeller. Luckily, most of these can be fixed at home.

How do you test a trolling motor?

You can briefly connect the trolling motor to a battery, then turn it on. Don’t run it this way for very long, though. If you want to run it for longer than a few seconds, fill a bucket or trash can with water and test it there.

IT IS INTERESTING:  Where do we get DC motor?

Where is the fuse on a Minn Kota trolling motor?

For that TM a 50 amp circuit breaker (or fuse) should be installed on the pos line at the battery. They could install one in the motor and it might help protect the motor but its not going to protect you.

Do I need a fuse for trolling motor?

The fuse amp capacity will need to be higher than the maximum amp capacity of the trolling motor. For example, if your trolling motor has a maximum capacity of 38 amps, you’ll need at least a 40- or 50-amp fuse.

How do you troubleshoot a Motorguide trolling motor?

Start by inspecting your electrical system to ensure power is reaching the motor. Check the connections at the battery terminals and the trolling motor. Clean battery posts with a wire brush when you discover corrosion and grime. Check the voltage on the battery, and replace if the battery will not hold a full charge.

Can you run trolling motor out of water?

Your motor is cooled by the water around it, while running it out of the water for a very short time would be OK, it would take a long time to drain the battery much running the motor out of the water with no load. Why risk damaging a very expensive TM to just drain the battery down.

How do I know if my trolling motor battery is bad?

If one battery drops more than the others, that one is probably bad. If the batteries are being charged fully, start the day at the same voltage and discharge equally, then they are probably all worn out. Just a regular voltmeter.

IT IS INTERESTING:  Best answer: How many miles can a Dodge 5 9 Cummins go?

Will a trolling motor work out of water?

Supreme Mariner. Re: Do electric trolling motors need to be in water to operate? Depending on the design of the motor stow and deploy mechanism, the motor may not operate in the stowed position. The motor does depend on water for cooling so don’t let it run for long periods of time out of the water.

What size fuse should I use for a trolling motor?

Depending on the trolling motor, you can choose between a 60 amp circuit breaker for trolling motors and a 50 amp circuit breaker for trolling motors.

What gauge wire should I use for a trolling motor?

In most cases, the manufactures recommended wire is 8 gauge for most 24-volt systems and 6 gauge for a system of 20 feet or longer. To account for voltage-drop, heat and current changes resulting from low batteries I recommend 6 gauge wire and 4 gauge for over 15 feet.

How many amps does a 45 lb thrust trolling motor pull?

40 to 45 lbs thrust is roughly 29 amps/hr instead of the 42 amps/hr that those respective motors draw for the same thrust.

How far should trolling motor be in the water?

Setting your trolling motor at an appropriate depth will help it to function properly, while at the same time reducing the risk of it becoming damaged. Remember, the general rule is to keep the motor submerged 12 inches below the water line.

Motorization