Why is trolling motor not working?

There might be a problem with the fuse or the circuit breaker. Make sure it is working right, and replace any fuses or switches that may have blown. The connections must be checked for any corrosion or loose wiring. … The main rotary switch of the trolling motor should be checked.

How do you test a trolling motor?

You can briefly connect the trolling motor to a battery, then turn it on. Don’t run it this way for very long, though. If you want to run it for longer than a few seconds, fill a bucket or trash can with water and test it there.

Do trolling motors have a fuse?

Generally speaking, trolling motors don’t come with the fuses or circuit breakers included, though the owner’s manual will probably recommend using one or the other.

How do you troubleshoot a Motorguide trolling motor?

Start by inspecting your electrical system to ensure power is reaching the motor. Check the connections at the battery terminals and the trolling motor. Clean battery posts with a wire brush when you discover corrosion and grime. Check the voltage on the battery, and replace if the battery will not hold a full charge.

IT IS INTERESTING:  Your question: Do jet engines have oil?

How do I know if my trolling motor battery is bad?

If one battery drops more than the others, that one is probably bad. If the batteries are being charged fully, start the day at the same voltage and discharge equally, then they are probably all worn out. Just a regular voltmeter.

Can you run trolling motor out of water?

Your motor is cooled by the water around it, while running it out of the water for a very short time would be OK, it would take a long time to drain the battery much running the motor out of the water with no load. Why risk damaging a very expensive TM to just drain the battery down.

Will a trolling motor work out of water?

Supreme Mariner. Re: Do electric trolling motors need to be in water to operate? Depending on the design of the motor stow and deploy mechanism, the motor may not operate in the stowed position. The motor does depend on water for cooling so don’t let it run for long periods of time out of the water.

Does a trolling motor need a circuit breaker?

If you are wondering whether installing a circuit breaker in your trolling motor is optional then, no. The Coast Guard requires that a circuit breaker or fuse must protect any ungrounded current-carrying conductor. Trivia: A tripped circuit breaker will prevent the current from passing onward.

How far should trolling motor be in the water?

Setting your trolling motor at an appropriate depth will help it to function properly, while at the same time reducing the risk of it becoming damaged. Remember, the general rule is to keep the motor submerged 12 inches below the water line.

IT IS INTERESTING:  Quick Answer: Why do fighter jets use low bypass engines?

Where is the fuse on a Minn Kota trolling motor?

For that TM a 50 amp circuit breaker (or fuse) should be installed on the pos line at the battery. They could install one in the motor and it might help protect the motor but its not going to protect you.

How many amps does a 45 lb thrust trolling motor pull?

40 to 45 lbs thrust is roughly 29 amps/hr instead of the 42 amps/hr that those respective motors draw for the same thrust.

Do you need a circuit breaker for a 12v trolling motor?

It is highly recommended that a circuit breaker or fuse be used when installing a trolling motor. Refer to the Minn Kota “Conductor Gauge and Circuit Breaker Sizing Table”. For motors requiring a 60-amp breaker, the Minn Kota MKR-19 60-amp circuit breaker is recommended.

Motorization