How do you change a prop on a trolling motor?

Are trolling motor props universal?

One of the great thing about MotorGuide trolling motors is that nearly all of their lower motor units are standardized at 3.5”, which makes changing or upgrading your prop incredibly easy! … Additionally, all props use the same MotorGuide Prop Nut Kit.

Can I put a bigger prop on my trolling motor?

Bottom line – a motor only has so much power and spin a propellor only so fast. If you try putting a larger prop on a motor that is not designed for it, the larger prop will simply spin more slowly so the net speed gain is 0 or negative.

What is the best battery to use for a trolling motor?

10 Best Trolling Motor Batteries Compared

Battery: Type: Reserve:
1. BPS Pro Series AGM X-900 AGM 195 min
2. Odyssey Trolling Thunder AGM 135 min
3. BPS Pro Series Deep Cycle AGM 150 min
4. VMAX Charge Tanks MR-137 AGM 230 min

How tight should a Minn Kota prop be?

It is recommended that you remove the propeller after every use to inspect for fishing line and weeds. NOTE: Only tighten the propeller nut / anode a 1/4 turn past snug [25-35 inch lbs.]. Over tightening can damage the propeller.

IT IS INTERESTING:  You asked: Where are FST carburetors made?

How do you remove a mount from a Minn Kota Maxxum trolling motor?

Re: Removing Motor From Maxxum Bow Mount?

  1. Remove the handle from the pull rope and pull it out of the “knuckle”
  2. Remove the retaining clip (it’s located on the inside of the arm, across from the latch) from the pin that goes through the bottom arm and the bottom of the knuckle, then remove the pin.


Is a 3 blade prop better than 2 trolling motor?

As a general rule the two blade prop = more power but less weedless. Three and four blades = less power but more weedless. An exception would be Minn Kota’s Weedless Wedge props. They’re two bladed but are very weedless and give lots of thrust at the same time.

How fast will a 40 lb thrust trolling motor go?

thrust trolling motor will still have a maximum speed of around 5 mph. If you are looking for quicker response time and better overall performance, bigger is better.

Is a 24v trolling motor faster than a 12v?

What you get in a 24v system is the ability to have a t-motor that delivers more “thrust”/power or more ability to push a (bigger) boat around easier and faster. You can have a lower thrust 12v t-motor wired with two 12v batteries and that will give you more hours of operating time.

How much weight can a 30lb thrust trolling motor push?

So the maximum for a 30lb thrust motor would be 30*100/2= 1500lbs.

How deep should my trolling motor be in the water?

Setting your trolling motor at an appropriate depth will help it to function properly, while at the same time reducing the risk of it becoming damaged. Remember, the general rule is to keep the motor submerged 12 inches below the water line.

IT IS INTERESTING:  Your question: What synchronous motor is not self starting?

Which prop pitch is faster?

The lower the prop pitch, the better your hole-shot. However, this comes at a price: top speed. The lower pitch makes the engine reach maximum rpm at slower speeds. Conversely, a higher pitch will deliver greater top speeds, but slower acceleration.